ELTIM CS-120ps, Output/Current stage/power supply module

Aprox 120Wrms/4Ω, incl. on board power supply.

ELTIM CS-120ps, Output/Current stage/power supply module
169,00 VAT% is Country dependent! After entering correct country you can login, register, search, etc. € 139,67 excluding VAT
Manufacturer ELTIM
Article codeCS120ps
0 star(s) in 0 review(s) Write a review
This CS-120ps power (current) stage + power supply module highlights:
  • Select power EXICON Mosfets of your choice
  • L-mounted to heat sink, which is electrically separated from the PCB.
  • Power capacitor location close to the power transistors.
  • On board rectifier and power supply capacitor bank (not included!).
  • Capacitor bank with 2x 2 high-grade, low impedance Ø25/30mm (pitch 10mm) possible.
  • For low profile / cost effective solutions a capacitor bank of 2x6 Ø18mm, pitch 7,5mm caps possible.
  • Resistor type selectable by the customer.
  • Possible large (Ø20x50mm) idle current MKP capcitor customer selectable.  
  • Current driven high power feedback in the centre of PCB with multiple paralleled resistors, reducing noise.
  • Speaker output screw terminals at left and right with 40A capability.
  • No output coil nor capacitor in the output line resulting in way better impulse and detail behaviour.
  • Protection circuit - or VS-regulator board connector.
  • Separate Current Stage and Voltage Stage power rails.
  • Seperate ground tracks for input, output, VS and CS ground.
  • Gold plated beryllium copper, milled connectors, with multiple pin (3A) connections.
  • Speaker signal for signalling/protection purposes at all connectors.
  • PCB position to mount an NTC/PTC at centre, connected to both horizontal connectors.
  • Idle current can be controlled and adjusted externally by a DC-signal coming from the centre connector.
  • Exactly fits in MODU Slimline/Galaxy 230mm deep versions.
  • Fits also in a MODU Dissipante 300mm and Mni Dissipante 250mm deep cabinets.
  • Dimensions: 228x104x35/50mm, depending on capacitor types used.

Production on demand.

Ready built and tested CS-120ps Current Stage module, built according to the bespoke requirements of the customer. Just make the selections of your choice above.
For a functioning amplifier you also need at least one of our VS-modules. These are the input part of the amplifier, CS-module is the output part.



Extra's:

Reviews

There are no reviews available in your current language
Write a review

Features and Specifications

To notice ELTIM
For a correct VAT% calculation, please select your country: